3
Installation and Commissioning
Camera Interface for WS1 Color and WS1000 Style
• Status: 07.03.2016• Technical Changes and Errors reserved.
•
Do not use the device if it is damaged.
•
Take the device or system out of service and secure it against
unintentional use, if it can be assumed, that risk-free operation is no
longer guaranteed.
The device is only to be used for its intended purpose. Any improper modification or
failure to follow the operating instructions voids any and all warranty and guarantee
claims.
After unpacking the device, check it immediately for possible mechanical damage. If it
has been damaged in transport, inform the supplier immediately.
The device may only be used as a fixed-site installation; that means only when assem-
bled and after conclusion of all installation and operational start-up tasks and only in
the surroundings designated for it.
Elsner Elektronik is not liable for any changes in norms and standards which may occur
after publication of these operating instructions.
2.2. Installation of the interface, connection
Please also take note of the chapter on the installation of the central unit in the manual.
2.2.1. Fitting the interface to the circuit board
WS1 Color:
1
Camera input 1
2
Camera input 2
3
Pins/connector plugs for the
camera interface
4
Fastening screw
1
2
3
4
Fig. 1
