Anti-Tamper Alarm
The PCKeypad uses a built-in LDR (light dependent resistor) as an anti-tamper
alarm. If the keypad is removed from the cover then the internal buzzer starts
beeping for 1 minute.
Reset to the Factory Default
To reset the Keypad to the factory default follow the steps below:
1.
Disconnect the power of the unit
2.
Press and hold the
*
key
3.
Reconnect power to the unit
4.
Release the key after you hear 2 beeps
The LED will turn amber for a few seconds and then change to flashing red with
one beep. This indicates a successful reset.
Programmed user ID and user PIN is retained even after factory reset.
Transmission time
The transmission time of the built-in PentaCode® transmitter is adjustable from
1 to 90 seconds. Factory default is 5 sec. See Programming Guide to change.
Sound and Light Indication
Operation Status
Red Light
Green Light
Yellow Light
Buzzer
Power on
Bright
-
-
Short Ring
Stand by
Bright
-
-
-
Press keypad
-
-
-
Short Ring
Operation successful
-
Bright
-
Short Ring
Operation failed
-
-
-
3 Short Ring
Enter into programming
mode
-
-
Bright
Short Ring
In programming mode
-
-
-
Short Ring
Exist from the
programming mode
Bright
-
-
Short Ring
Open the door
-
Bright
-
Short Ring
Alarm
Bright
Short Ring
Содержание PCKeypad
Страница 1: ...User Manual PCKeypad Wireless Keypad...