- 7 -
Camera installation
Important
•
Before mounting, check the signal of the system by viewing the live feed of the camera on the
monitor from the same location/position as where the camera is mounted.
•
The location should be free of dust and not in view of a strong light source or direct sunlight.
•
Avoid thick walls or obstacles between the camera and the monitor.
•
This camera has built-in IR LEDs that allow you to view images under no/low light conditions.
•
The 6 x 6 Watt LEDs make it possible to view color images in no/low light conditions; Color
Night Vision technology. The lighting can be switched on manually, with a timer setting and
automatically after motion detection.
Mounting the camera
1.
Mark the position of the screw holes using the mounting bracket on the wall.
2.
Drill the holes and place the 4 dowels in the holes.
3.
Attach the camera, insert the screws through the mounting bracket into the plugs and
tighten them firmly.
4.
Now point the camera at the area you want to secure
5.
Connect the 5V DC/ 2.0A) power adapter (see the bottom of the mounting plate) to the
camera
6.
Press the plugs together tightly to prevent moisture from entering.
Note
You can install additional cameras (up to 4 cameras). When you add cameras that were not in the
original box, you must pair the cameras with the monitor. Refer to section 4.1.1 Camera setup -
Pairing about pairing the cameras in this manual.
Overview menu screens
This chapter describes the monitor's pop-up menu screens in detail. Tap this on the
tablet and the following pop-up menus are displayed.
1.
Light settings
2. Alarm volume
3. Brightness
4. General Settings
