1
SP205+
DUAL 1x5 VIDEO & AUDIO DISTRIBUTION AMPLIFIER
ELPRO Video Labs s.r.l.
Str.da della Pronda, 45/B 10142 TORINO - ITALY
Tel.+39 0117701583 – Fax +39 011703751
6
3.1.2 Single 1x10 distributor
To use the unit as 1x10 single distributor, proceed as follows:
a) Make sure that all the units to be installed are OFF.
b) Set the switch on the front panel to the “1x10” position remembering
that this setting acts not only on the video but also on the audio.
c) Connect the video source to one of the two IN1 connectors
d) If the input signal is not terminated at 75
Ω
, set the switch referring to
the IN1 input (located to the left of the related BNCs) to the ON position.
If the signal is already terminated at 75
Ω
, set the switch to OFF. The
position of the switch relating to IN2 is not significant in this operating
mode.
e) The BNC not used, relating to input IN1, can be left free or can be used,
if necessary, to send the video signal to other units. In this case,
remember that termination at 75
Ω
must be carried out at only one point
of the chain, preferably at the end of this. Therefore, in this case, the 75
Ohm switch must be set to a OFF.
f) As the two IN2 connectors are not used in this operating mode,
connection of these is not significant.
g) Connect the destinations to the “VIDEO OUT” BNCs.
h) Power the SP205+ and other system units.
