SP205+
DUAL 1x5 VIDEO & AUDIO DISTRIBUTION AMPLIFIER
ELPRO Video Labs s.r.l.
Str.da della Pronda, 45/B 10142 TORINO - ITALY
Tel.+39 0117701583 – Fax +39 011703751
5
3.0 INSTALLATION
3.1 Video
section
3.1.1 Dual 1x5 distributor
To use the unit as dual 1x5 distributor with two sources, proceed as follows:
a) Make sure that all the units to be installed are OFF.
b) Set the switch on the front panel to the “DUAL 1x5” position
remembering that this setting acts not only on the video but also on the
audio.
c) Connect the first video source to one of the two IN1 connectors and the
second source to one of the two IN2 connectors.
d) If the input signal is not terminated at 75
Ω
, set the matching switch to
the ON position. If the signal is already terminated at 75
Ω
, set the
switch to OFF. The switch of input IN1 is located to the left of the
respective BNCs, that of input IN2 is located to the right.
e) The input BNC not used can be left free or can be used, if necessary, to
send the video signal to other units. In this case, remember that
termination at 75
Ω
must be carried out at only one point of the chain,
preferably at the end of this. Therefore, in this case, the 75 Ohm switch
must be set to a OFF.
f) Connect the destinations to BNCs 1÷5 “VIDEO OUT” on both sections.
The BNCs at the top refer to section 1, those at the bottom refer to
section 2.
g) Power the SP205+ and other system units.
