ELPRO LIBERO Tx, Руководство по эксплуатации

Страница: 62 / 80

62 - EN liberoCONFIG
LI6002Eg
EXAMPLE - TRANSPORTATION
5
5.3.2 Statistics
LIBERO Tx have the capabilities to calculate and display statistical data.
Data logging continu-
ous during the evalua-
tion. There are 3 possibilities for the statistic calculation:
- Graphics & Alarmhandling all values in Memory
- Graphics & Alarm handling "Last Transit - Arrived"
- Graphics all values in Memory & Alarmhandling "Last Transit - Arrived" period

3.4.6 PDF Options - Inspection Range
5.3.2.1 Display of statistical data
• To access the statistical data, press the TRANSIT-button. Hold down the button while
you briefly press the ARRIVED-button. The status change is confirmed by the display
test.
• After the release of the buttons, the statistical data are shown.
• For an immediate exit, press the TRANSIT-button again or wait approximately 10
seconds till the LIBERO Tx displays measurement values again.
P-Id
Depending on the pro-
file settings, the Profil-
ID will be shown as
first statistic value.
Browse
The buttons allow to scroll through the statistical data:
• Step forward - press ARRIVED-button
• Step backward - press TRANSIT-button
Evaluation Modes
There are two different evaluation modes available. Depending on the selected mode, con-
tinue with:

5.3.2.2 Single Alarm Thresholds or

5.3.2.3 Multiple Alarm Zones
To enable this function:

3.4.3 Alarm conditions
5.3.2.2 Single Alarm Thresholds
Profile-ID
If "Show Profil-ID on LCD" is selected, the ID will be shown after the display test.

3.4.9 Profile Information
If for the "Last Transit - Arrived" periode, the ARRIVED-button was not pressed,
all values until the moment of evaluation will be used.
P-Id Abbrevation for: Profil-ID