1000356V01 DOC - ECOLOG-PRO RBR and 1NTR - Operation Manual_EN | Page 8 / 13
Logging and communication interval
1, 2, 3, 5, 10, 15, 20, 30, 60 minutes; user programmable via software (ELPRO
Cloud)
NOTE: Logging interval will impact battery life
Channels
1 temperature channel
Probe type
Internal NTC probe
Memory capacity
14'800 measurement values
Environmental storage temperature /
humidity
-10 °C..+50 °C
10 %RH..90 %RH, non-condensing
Environmental operating temperature
/ humidity
-35 °C .. +50 °C, depending on batteries used (see 'Measurement range')
0 %RH..100 %RH
Operating altitude
This device must not be used at altitudes higher than 2000 meters above sea
level.
IP protection class
IP67
ID number
"S" followed by a 6-digit number; the ID number is used to identify the module in
the ELPRO Cloud software.
Radio connection to communication
module
Available in two versions: 868 MHz (Europe) or 915 MHz (US)
Left and middle LED (Link)
:
Red flashing light on left LED: ECOLOG-PRO 1NTR is active but is not connected to
a communication module (ECOLOG-PRO RBR)
Green flashing light on middle LED: ECOLOG-PRO 1NTR is active and connected to
a communication module (ECOLOG-PRO RBR)
The interval of the flashing light is 10s.
Right LED (Data):
Green flashing light on right LED: Measurement on the channel has started.
Everything is OK.
The interval of the flashing light is 10s.
How to connect:
Make sure that you have defined the sensor's settings in the ELPRO Cloud software and that the "Add
sensor" wizard shows the image displayed above. This gives you a 10 minutes time frame to connect
your module via the following steps:
1.
Open the measurement module's screw cap.
2.
Insert the two AAA batteries.
