Seite - 27
05. 2009 AG
D-EL-6003Bj
ECOLOG-NET
3.2.4 elproLOG ANALYZE
Set the datalogger parameters;
)
SE3401E
3.2.5 elproLOG MONITOR
This program is used for on-line display of measured values.
Refer to the instruction manual for a detailed description for the
functions and applications
)
SM3001E.
3.2.6 Installation verification
Check the installation and make sure that sensor positions, alarm
parameters and network address are correct. To help, use auxiliary
devices (e.g. calibration connector) in order to simulate defined
measured values.
4. Addendum to elproLOG manual
4.1 Datalogger setup
Window "Datalogger Setup" is used to define the implemented measuring parameters.
For detailed information about the following points
)
elproLOG manaul, D-SE-3002B, Chapter 5.8.1
...P4 ...H2
x
x
Log Mode
x
x
Log Start
x
x
Log Interval
x
x
Module Tag
x
x
Zoom Preset
x
x
Sensors
x
PIN
4.2 Extended Setup
...P4 ...H2
x
Low point calibration...
x
High point calibration...
x
x
Direct calibration by values...
Use these 3 functions to calibrate the datalogger
x
x
Define alarm parameters...
)
)
)
)
)
Chapter 5
x
x
Reset alarm
Use to acknowledge and reset an alarm message.
x
x
Set date and time...
Use to adjust the built-in datalogger clock.
x
x
Logger Display...
)
)
)
)
)
Chapter 2.7
x
Configure communication settings...
No function in this version
x
Terminal mode parameters...
No function in this version
x
Set language...
No function in this version
x
Select printer...
No function in this version
x
x
Set temperature unit...
Use to select the used unit of temperature.
You can choose between °C and °F.
x
Set mean value measurement parameter...
Use to suppress line frequency interference.
x
Set new password...
x
x
Programming of battery change time
Use to restart the datalogger after battery replacement
(
)
)
)
)
)
Chapter 2).
English
Manual
