D-EL-6003Bj
05. 2009 AG
Seite - 36
ECOLOG-NET
7.5 Status and error codes; datalogger type ...H2
7.5.1 Datalogger display
CAL
Calibration active
Strt
The datalogger is waiting for log start in accordance with the settings at menu point:
Datalogger setup
StOP
The logger is in Start/Stop mode and the memory is full.
No further measured values can be logged.
Reprogram the logger to restart logging.
This is the delivery status of the datalogger type ...H2.
Ld.
The configuration data are automatically uploaded to the datalogger when the rH/T
sensor is connected.
Prn
Data are printed
b.F.
Battery voltage is too low
CAL.E. Error during calibration
C.F.
Faulty datalogger
Err
Error during printing
HHHH Faulty datalogger keypad
L.C.
Faulty datalogger
Ld.F.
Error during loading of rH/T sensor parameters
n.c.
No sensor connected
S.C.
Sensor has short-circuit
O.F.
Measured value exceeds allowable maximum
U.F.
Measured value is lower than allowable minimum
7.5.2 Status of datalogger in elproLOG ANALYZE ...H2
RAM IMG-BMP destroyed
This error message appears at datalogger status in line: Module time. The cause of this error message can,
for example, be a battery change when the battery change time was not programmed (
)
)
)
)
)
Chapter 2.13).
7.6. Notes; datalogger type ...H2
Software
ECOLOG-NET dataloggers require evaluation software, version 3.31 or higher.
CD-ROM
Refer the elproLOG CD-ROM for further product information.
No Connection (USB or LAN)
Reaction: enlarge the timeout parameters in communication settings:
- elproLOG ANALYZE (Options - Com Port... - Extended)
- elproLOG MONITOR (Tools - Options - Communication Timeouts)
Logging measured values
...H2 dataloggers can not log measured values during communication with the
elproLOG ANALYZE or elproLOG MONITOR software!
Manual
广州虹科电子科技有限公司
广州市五山华南理工大学国家科技园 2 号楼 504-505 室（510640）
电话： 020-3874 3030; 3874 3032 e-mail:
网站
：
www.hkaco.com
