ELOVIS
1 Introduction
1.4 I
NSTALLATION AND
C
OMMISSIONING
Check.
1. Please check whether you received all components listed in the scope of delivery.
2. Please check every single delivery component. If you see damages or in case of
missing components, please do not set the unit into operation, but contact:
ELOVIS GmbH, Karl-Friedrich Str. 14-18, D-76133 Karlsruhe, Germany
Tel.: +49 (0) 721 / 933 823-0; Fax: +49 (0) 721 / 933 823-23
Mounting
µSPEED-smartsensor
.
Danger of eye damage from class 3B laser!
Never use the measuring unit when it is not mounted!
1. The alignment of the measuring unit has to be perpendicular to the measured object.
It should be mounted at an angle of 90 degree and at a distance of 120mm (+/- 3mm
to +/-5mm) or 240 mm (+/- 10mm) from the measured object (see Figure 1). The rules
and regulations of laser protection must be followed (see chapter 3).
Figure 1: Mounting tolerances and alignment of
µSPEED-smartsensor
2.
µSPEED-smartsensor
must be mounted electrically isolated (no contact with machinery
ground). The PVC plate and plastic screws which are included in the scope of delivery,
should be used for this purpose.
Electrical connection of
µSPEED-smartsensor
.
1. Connect the delivered sensor cable with the
µSPEED-smartsensor
.
2. Interconnect/wire the other end of the sensor cable according to the designated
functions.
3. Interconnect/wire the emergency shut-off input
Fehler! Verweisquelle konnte nicht
gefunden werden.
according to the laser protection directions (see detailed information
in chapter 3.1.2). The shut-off input has to be connected to a key switch (which is not
ID308
3
