Elo TouchSystems Entuitive 1229L, Руководство пользователя

Страница: 192 / 249

Appendix A. Installation and Setup
69
Command syntax summary
Command Syntax Meaning
mtcfg
list installed MagTek device drivers
mtcfg -?
display a help page
mtcfg -help
display a help page
mtcfg -models
list available MagTek device models
mtcfg
port-name
list settings for a given device
mtcfg
port-name
–all

more
verbose list of settings
mtcfg
port-name model
[
settings
]
* add and configure a new device
mtcfg
port-name
–delete
* delete a device
mtcfg
port-name settings
* change settings for a device
* these commands require Administrator privilege. MTCFG will display an error
message if the current user is not an Administrator.
Displaying Configuration Information (WNT/2000/XP)
To display the list of configured MagTek devices, use the following syntax:
mtcfg
To display the settings for a single device, use:
mtcfg COM x
COM x is the name (virtual port) of the device, as set when the device was first
configured. This name is shown in the leftmost column in the list of devices. This
command displays only the common settings for the device
−
the ones that are most likely
to require modification. To display all device settings, including all data parsing format
strings, use the following syntax:
mtcfg COM
x
–all | more
The pipe symbol and “more” will present the information one screen at a time.
Adding New Devices (WNT/2000/XP)
To add a new device use the following command syntax:
mtcfg
port-name model
or
mtcfg
port-name model settings
port-name is the name (virtual port) chosen for the new device. It must not be used
by another device in the system (MagTek or other). The port name in the
form COM
xxx (valid values are COM5 .. COM255). MTCFG will verify
that the name is not used by other MagTek devices that were set up with
this utility, but it will not check whether the name is used by any other
device in the system.