Elo TouchSystems AccuTouch 821615-000, Руководство по эксплуатации продукта

Страница: 20 / 107

3-25
2210MX External Serial Controller
Contents
This configuration includes a 2210 serial controller in a small enclosure with a
keyboard power tap or external power supply and connecting cables.
Installation
Complete these steps:
1 Configure the controller
2 Connect the touchscreen controller and the supplied cables.
Configure the Controller
The controller is shipped preconfigured for use with Elo software. No changes
are necessary for most users. Specific settings and options available for your
controller are listed in Appendix B.
The 2210MX External Serial Controller is typically shipped configured at 9600
baud. If your software does not support the 2210 directly, you may operate the
2210 in E271-140, E261-280, or E281A-4002 emulation modes. See B for
jumper settings.
Additional technical information about the 2210 controller can be found in the
SmartSet Touchscreen Controller Family Technical Reference Manual,
available at
www.elotouch.com/support/dwnldmnls.asp .
Connect the Controller
CAUTION Before using a keyboard power tap, be sure sufficient power is available for the
touchscreen controller or damage may occur to the computer.
Before connecting a keyboard power tap to the controller, be sure that power to
the computer is OFF. Connecting a keyboard power tap to a powered computer
may seriously damage the computer or the controller.
Complete the following steps if you are using a keyboard power tap:
1
Two different keyboard power taps are available. Use Elo P/N 980773-000 if
you have a standard keyboard connector and Elo P/N 388923-000 if you have
a PS/2 keyboard connector.
2
Unplug the keyboard from the computer.
3
Plug the male connector on the Y end of the adapter cable into the keyboard
connector on the back of the computer.