13
4.- OPERATION
REMOTE CONTROLLER OPERATION
Infrared IFC-2000 is operated using the remote control supplied with the heater. Insert 2 x AAA Alkaline
batteries into the remote control.
Note
: All IFC2000 units and their remote controls have the same frequency, so it is possible to control several
IF2000 units with just one remote control.
Timer Adjustment
Press Timer button (5) and use the Up and Down buttons (2) and (3) to select the number of hours the heater
will be working. The heater will be working providing the selected heat level during these hours. When the time
has finished, the heater will automatically disconnect the heating elements.
Inserting Batteries
Insert 2 AAA/ Alkaline type batteries into your remote control
1.
Flip the backside of your remote control and pull out battery cover. Insert the batteries in accordance with
the instructions and polarity of the batteries.
2.
Change the batteries in the same way described above.
Warning:
1.
Replace the old batteries with the same type batteries. Otherwise, your heater may not function well.
2.
Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your remote
control.
3.
Do not allow water or liquid to get into the remote control.
5.- TROUBLESHOOTING
E1 Error on display
Control Unit Overheat. Check installation clearances. Let heater cool for 15 minutes
and restart heater.
E2 Error on display
Tip over function. Make the heater working less than 60º angle and restart the heater.
No heat when L1,2,3
Bulb is damaged. Contact Technical Service.
o 4 shown on display
Remote Control Function
Button
Function (Heater On) Function (Heater Off) LED Display on
Heater
1
Turn the heater off
Turn the heater on
2
Increase Heat Level or
Timer hours
Turns heater on to
Level 4 (maximum)
L4
3
Decrease Heat Level or
Timer Hours
Turns heater on to
Level 1 (minimum)
L1
4
Enable Heat Level
adjustment
L [n]
5
Enable Timer adjustment
[0H]-[24H]
