ELNA expressive 940, Инструкция по эксплуатации

Страница: 20 / 87

16
Winding the Bobbin
z
Place the thread cone (spool of thread) on the rear
most spool pin.
Pass the thread through the thread guide A .
q
Thread guide A
x Pass the thread through the upper hole and lower
hole in the thread guide B .
w
Thread guide B
c Draw the thread to the front.
Hold the thread with both hands and pass the
thread firmly around and under the tension disk.
e Tension disk
v
Pass the thread through the hole in the bobbin
from the inside.
Put the bobbin on the bobbin winder spindle.
r
Hole in the bobbin
t
Bobbin winder spindle
b
Push the bobbin winder stopper up against the
bobbin.
y
Bobbin winder stopper
n Press the bobbin winding button while holding the
thread end.
u Bobbin winder button
m
Press the bobbin winder button to stop the
machine when the bobbin has wound a few layers.
Cut the thread close to the bobbin and press the
bobbin winder button again.
, When the bobbin is fully wound, the machine will
stop automatically.
Remove the bobbin from the bobbin winder
spindle.
.
Cut the thread with the bobbin thread cutter.
i
Bobbin thread cutter
z x
c
v
b
n
m
,
.
q
w
e
r
t
y
u
i