ELMOT 026, Руководство пользователя

Страница: 14 / 44

14
Recommendations for preserving battery life:
•
Do not charge the appliance every day.
•
Completely drain the battery every six months, then recharge following the in-
structions described in the paragraph “USING FOR THE FIRST TIME”.
•
Do not charge the appliance for longer than the recommended time; overcharg-
ing reduced the life of rechargeable batteries.
Fully charge the appliance at least once a year.
Do not try to change the batteries yourself. Refer to an au-
thorised customer service centre.
USE
ATTENTION! Do not use the appliance if the blade of head 2 (fig.
A
) is
damaged or if the blade block is not working correctly.
Do not use the appliance on wet hair.
Elmot 026 Professional Clippers are ideal for trimming hair and beard.
It is possible to adjust the cutting height to eight distinct levels and use two different
cutting speeds: normal and turbo.
TURNING THE APPLIANCE ON AND OFF.
Turning on
•
Press button
14
(fig.
A1
); LED
14.1
(fig.
A1
) lights up red and the display comes
on.
Turning off
•
Press button
14
(fig. A1 ); LED
14.1
(fig. A1 ) and display go off.
The LCD display takes approximately 3 seconds to turn off completely.
TURBO FUNCTION TURNING ON AND OFF
Turning on
•
Press button
13
(fig. A1 ); the wording “TURBO” will appear on the display (ref.
20
,
fig. A1 ).
Turning off
•
Press button
13
(fig. A1 ); the wording “TURBO” will disappear from the display
(ref.
20
, fig. A1 ).
ATTENTION! With the ''TURBO'' function inserted, autonomy of the
battery decreases.
USEFUL TIPS FOR CUTTING
• Wash the hair as usual, dry and brush it in the direction of growth to untangle
any knots.
• After drying, do not use hairspray, mousse or gel.
•
Start at the highest setting of the supplied guide comb (12 mm) and gradually
reduce the setting of the hair length using the other guide combs supplied (9-
6-3 mm).
• For best results, use the appliance against the direction of hair growth.
•
If hair starts to clog the guide comb, remove the guide comb from the appli-
ance (see par. “Removing the guide comb”) and clean away the hair (blow and/
or brush out).
• To have a clean, precise cut of thick or long hair (one pass), press button
13
(fig.
A1 ) to activate the “TURBO” function.
USING THE APPLIANCE
Use of the cutting guide comb.
To insert the guide comb (fig. A2 ) follow the instructions below:
• Check that the appliance is off.
•
Slide the guide comb onto the head until you hear it click into place (Fig. C ).
• Ensure that the guide comb is correctly inserted in the slots on either side.
•
Turn on the appliance as indicated in par. “TURNING THE APPLIANCE ON AND OFF.”
• Cut the hair; for tips see par. “USEFUL TIPS FOR CUTTING”.