ELMOT 026, Руководство пользователя

Страница: 15 / 44

15
Turn off the appliance before changing or inserting any accessories.
Removing the guide comb
• Turn off the appliance.
• Push the guide comb so that it slides off the appliance (Fig.
C1 ).
Using without the guide comb.
When using the appliance without the guide comb, the blade of the
head (2) will cut the hair very close to the skin.
The appliance can be used without the guide comb to cut hair very close to the skin
(1.0 mm) or to redefine the hairline of the neck and around the ears.
If the appliance has been used with the guide comb and is then to be used without it,
remove the comb as described in par. “Removing the adjustable guide comb.”
Instructions to adjust the cut.
Elmot 026 clippers has four adjustable lengths: 1.0 /1.3/1.6/1.9 mm.
To adjust the cutting length, push the lever upwards
11
(fig. A1 ) in the direction
of the blade to cut very short hair ( minimum height 1.0 mm ).
Press the unlock button
12
(fig. A1 ) and shift the lever downwards to cut longer
hair ( maximum height 1.9 mm ).
When cutting close to the ears, you are advised to use
your hand to protect your ear against injury.
MAINTENANCE
GENERAL CLEANING
Always disconnect the power cord from the mains socket before cleaning.
Avoid all risk of electric shock by not cleaning the appliance
with water and do not immerse it in water.
Do not use abrasive solutions or concentrated detergents.
• Clean the exterior with a soft cloth or slightly damp cloth.
• After use, make sure that all parts are completely dry.
Removing the cutting head
•
Turn off the appliance and remove the power adaptor from the mains socket
9
(fig. A ).
•
Remove the guide comb in compliance with the instructions reported in “Using
without the guide comb.“
•
Keep the appliance with the display facing upwards.
• Press the centre part of the head downwards
2
(fig. A ) using your thumb until it
has opened (fig. D ); then extract it from the appliance.
• Take care not to drop the head.
Blade block cleaning
•
Remove the head
2
(fig. A ), as indicated in the paragraph “Removing the cutting
head.”
•
Using the supplied brush
8
(fig. A ), remove hair:
– from the internal part of the appliance (fig. E );
– from the ends of the blade (fig. E1 );
– from between the fixed
A
and mobile
B
blade: to lift the blade, apply downward
pressure on the cleaning lever
C
(fig. E2 ) .