3
Preparation to work
1) Unpack the device.
2) Inspect all parts of the water thermostat for damage.
3) Put device on horizontal solid surface.
4) Connect the control block to the tank by fixing the screw in the back.
5) Fill the reservoir with 6 liters minimum of
distilled
water (do not use any electrolyte solvents).
6) Plug the cord into the outlet with voltage of 220 V and frequency of 50 Hz.
Control description
Water thermostat consists of a plastic tank and control block. Water tank is covered with
transparent lid. The control block displays and buttons have the following functions:
Displays the current or set temperature.
Buttons to adjust the temperature.
Displays the level of water circulation in tank
or water flow speed in external heating pipes.
Buttons to adjust the level of water circulation in
tank or water flow speed in external heating pipes.
Buttons to turn on or off the device.
Operation
Turn on the device by pressing
button and set the desired temperature by
buttons.
The device will start heating up immediately. The set temperature is displayed for the first 10
secconds after adjusting, after wards the actual temperature is displayed.
To check the set temperature press one time on the button for adjusting the temperature.
The dot on the temperature display separating the integers from tenths of a set temperature
value indicates what temperature is displayed:
if the dot is blinking - set temperature is displayed,
if the dot is glowing - actual temperature is displayed.
Set the desired water circulation level in tank or water flow speed in external heating pipes
form 2-5 liters per minute by pressing the
button.
