6
Technical Support: 023 9269 6638
PAK200838_03A Feb 2019 ©2019 ELMDENE INTERNATIONAL LTD
Table 2: Summary of symptoms and possible faults
Symptom
Fault
Action
Sounder cannot be silenced
BL+ holdoff input is not > 7V
Verify that the control panel is biasing BL+ to
>7V in standby mode.
Holdoff supply (ALIM) is disconnected
or very low
Check integrity of holdoff (ALIM) supply
Sounder stops after 5s
Incorrect timer link setting
Set correct timer jumper links.
Tamper condition indicated
at control panel or cannot
SET control panel
(due to sounder tamper)
Tamper outputs (AP) not connected
correctly to panel.
Refer to connection diagram Figure 2
Tamper switch not closed
Check cover
No response to BL+ input
Battery not connected
Check battery connections to terminal block
Battery faulty or voltage low
Replace battery
Battery charger faulty
Return unit to manufacturer
Audible alarm stops before
timeout.
Battery level very low
Recharge battery
D
ISPOSAL OF
P
RODUCT AT
E
ND OF
L
IFE
This product falls within the scope of EU Directives 2012/19/EU Waste Electrical and Electronic Equipment
(WEEE) and 2013/56/EU (Battery). At the end of life, the product must be separated from the domestic
waste stream and disposed via an appropriate approved WEEE disposal route in accordance with all national
and local regulations.
Before disposal of the product, the battery must be removed, and disposed of separately via an appropriate
approved battery disposal route in accordance with all national and local regulations. Package used batteries
safely for onward transport to your supplier, collection point or disposal facility.
Caution: Risk of fire or explosion
if exposed battery wires are allowed to touch.
See Specification for battery type information. The battery is marked with the crossed out wheelie bin
symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg).
The packaging supplied with this product may be recycled.
Please dispose of the packaging appropriately.
For more information see:
F
AULT
F
INDING
