15
MAINTENANCE
HOW TO PROGRAM A PERSONALIZED LOGO
The logo that will be printed on each receipt is saved in the printer in a no-
volatile memory. To change it you need to have the LOGOMAKE program from
Custom Engineering this is available for download from their website:
www.custom.it
. The logo has to be in .bmp format, black-and-white and may
have the following dimensions: width 448 points, height 585 points. Instead,
the part of logo that will be printed has to be of 448 x 182 points, starting at
the top. The printer has three banks in which the logos can be saved, the
Ticket Eater uses LOGO1.
REPLACING THE SACK
The tickets sack is placed in the lower door of the machine, fixed to the sliding
bracket. Pull out this bracket and withdraw the full sack. Fix the new sack on
the bracket and re-insert it fully in its place.
Replacement Ticket Sack
available from Electrocoin Aftersales (Part no 61ELMACBAG)
NB. The contents of the sack is recyclable material that is conferred in special
container marked by CA brand (paper).
REPLACING THE PAPER FOR THE PRINTER
The necessity to replace the paper-roll is indicated by the message “PRINTER
ERROR”, even if remains a little bit unused paper. Proceed in this way:
•
Open the lower door, the machine will turn OFF (any tickets counted will
not be lost).
•
Pull off the plate bracket to facilitate the operations.
•
Turn ON again the machine, pulling the upper security switch off (Fig.5).
•
Move the green lever out for lifting the print-head (Fig.6).
•
Remove the remaining paper from behind.
•
Bring the green lever again to its original position (Fig.6).
•
Release about 20 cm of paper from the new roll, be sure that the end of
paper is perfectly cut, without flaws, and that the cutting is perpendicular
to the paper.
•
Insert the paper into the rear slot, until the printer charges it and cuts it
automatically.
•
Place the roll in its roll-holder.
•
Close the door.
Replacement rolls available from Electrocoin Aftersales
(Part no. large Roll 68ELMACLGE small roll 68ELMCSML)
