Elliott Roto-Jet 0420, Инструкция по эксплуатации и техническому обслуживанию

Страница: 14 / 27

14
0420 Roto-Jet
• Replace the machine cover and test for proper assembly.
• If the machine is still sluggish and inefficient call an Elliott service facility.
• Recommended solvents for flushing are:
DEM-Kote 2X726
Loctite Safety Solvent
Inhibisol Safety Solvent
The vanes in the air motor are designed to give between 5,000 and 15,000 hours of operation under
normal conditions and with the proper lubrication. If you suspect that the machine is in need of new
vanes contact the Elliott service location. (Repair kit 04230 is available.)
Under normal conditions other lubrication of the machine between uses is not necessary, unless the
machine has been operated “Dry”. Should you wish to use the Roto-JetTM dry, the manifold drive
shaft must be lubricated with a few drops of oil. Position the machine vertically, taking care not
to damage the throttle valve or air supply coupling. Use a standard long spout oil can to place oil
behind the brass square drive coupling. Using the machine dry after it has been used for wet opera-
tion, could damage the seals and bearings, which may require replacement if not lubricated.
Clean dust and debris from vents. Keep the machine handles clean, dry and free of oil or grease.
Your machine has been finished with a two-part, epoxy, paint coating that is very durable and should
last the life of the machine. Use only mild soap and a damp cloth to clean your machine. Certain
cleaning solvents can be harmful to the painted surfaces. Never use flammable or combustible sol-
vents around machines.
After each use, drain all water from the flexshaft outer casing. Store the flexshaft by laying it down,
in a large diameter coil, in a dry, secured area.
After every cleaning season or 12 months remove the machine cover and check the motor coupling
set screws for proper tightness. Inspect the coupling for alignment and verify the connections of
the tubing within the machine. Replace the cover and position the machine vertically. Lubricate the
manifold drive shaft, behind the female brass square drive coupling with a few drops of oil. An oil
can with a standard long spout will be required. Make sure the flexshaft casing is drained of all wa-
ter. Lubricate the flexshaft with a water soluble lubricant solution diluted to the manufacturers rec-
ommendations. An oil can with a standard long spout will be required. Position the spout between
the flexshaft core and the casing. Fill and drain the flexshaft from both ends. When finished, store
the flexshaft by laying it down, in a large diameter coil, in a dry, secured area. Start the next cleaning
season by operating the machine prior to starting a new job. For more information on proper opera-
tion see “Operation” section.