page 4
5. Fan Assembly
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
6in. downrod provided to use with an extended
downrod (sold separately). [
If you wish to use the
6in. downrod, please proceed to instructions
following the dotted line below.
]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top of
the downrod should be noted as having a set
screw hole; use this hole when setting the set
screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop pin
aligns with slots on the inside of the hanging ball.
Tighten set screw securely.
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts at top of motor assembly.
Remove pin and clip from yoke at top of motor
assembly. Slide downrod through canopy, canopy
cover and yoke cover. [
Note
: Canopy cover must be
turned with shiny side
toward
the motor assembly.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Thread downrod into the yoke at top of motor
assembly until holes for pin and clip in downrod
align with holes in yoke--
make sure wires do not get
twisted
. Re-insert pin and clip. Tighten yoke set
screws and nuts securely. Lower yoke cover to
motor assembly.
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
set screw hole
set screw
hanging ball
stop pin
A
B
safety cable
downrod
electrical wiring
canopy
yoke cover
motor
assembly
yoke set screw
clip
pin
canopy cover