page 11
It is recommended that you test fan before
finalizing installation. Locate ON/OFF slider switch
on wall control and set to the ON position. Test
light and dimmer function and then test fan
speeds. Next, locate remote control transmitter.
Test fan speeds with the different fan speed
buttons on remote control. Test the light ON/OFF
function with the button on the remote control.
Test dimmer function by holding down the
button for more than 2 seconds. (
diagram 1
) If the
remote control operates all of the functions of the
fan and light, battery has been installed correctly. If
fan and/or light do (does) not function, please refer
to "Troubleshooting" section to solve any issues.
Turn fan completely off
before
moving the reverse
switch (located under yoke cover). Set reverse
switch to recirculate air depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
NOTE
: If the remote control interferes with other
appliances, change code switches on the
transmitter (AND wall control) to another code. If
you do change the code,
turn power off first
,
remove the battery cover, and, after setting the
new code, go back to the instructions in the last
paragraph of Section 10 (page 9).
13. Testing Your Fan.
diagram 1
diagram 2
diagram 3
diagram 4
remote control
transmitter
wall
control
reverse switch