24
ELR60RT 2PH/60
5. INSTALLATION PROCEDURE
The EL60RT barrier can be installed either on a wall, using the fixing plate, or on a pole, using the U-shaped bracket
(48-50
∅
pole). To do this:
•
Remove the cover by unscrewing the screw located on the front.
•
Loosen the screw securing the plate and remove it by sliding it down against the base.
WALL MOUNTING
•
Fix the plate to the wall with the screws.
•
Insert the battery and secure it with the clip.
•
After checking the alignment and correct operation, refit the cover and firmly tighten the closing screw.
POLE MOUNTING
•
The supplied brackets allow mounting on poles with a diameter of 48-50 mm.
•
Drill an 8mm diameter hole in the pole for the connection cable to pass through.
•
Place the U-shaped brackets on the pole and fix them to the plate with the screws provided.
•
Make the connections on the terminal board.
•
After checking the alignment and correct operation, refit the cover and firmly tighten the closing screw.
6. INSTALLATION TIPS
•
For correct product installation, all potential obstacles must be removed from within the space between
the transmitter and receiver column (trees, grass, etc.), using irremovable walls or poles firmly anchored
to the ground for the installation.
•
Necessary precautions must be taken in order not to alter the barrier’s performance and (IP) protection
rating. Take care not to damage the gaskets, plastic and mechanical parts of the product, and use original
accessories.
•
Avoid installing the receiver in a position where the sun’s rays can directly affect the optics.
