Page 12
1000003419 (Rev. A - 03/16)
WARNING
Installation
For correct and safe installation, please read these instructions completely.
•
All Installation work must be performed by an authorized service personnel.
•
Disconnect electrical supply serving the Installation area to reduce risk of electrocution.
• Unit not suitable for installations where water jets could be used.
DANGER
Assembly
1. Open the top of the box, remove the foam and its accessories (includes 4 filters and 1 valve).
2. Place the accessories aside.
3. Unpack the product, install the water drip tray and grid.
4. Cut PE tube to appropriate length. Connect PE tube to water inlet of water dispenser. Connect other end of PE tube to suitable water inlet line.
5. Cut PE tube to appropriate length. Connect PE tube to water outlet of water dispenser. Connect other end of PE tube to suitable drain line.
Water Supply
Outlet
Inlet
6. Install the filter. Align the filter to the filter receptacle. Insert the filter according to the arrow direction until it reaches the end of the receptacle. The
filters include the following (from left to right): Polypropylene Filter, Pre Carbon Block Filter, Reverse Osmosis Filter, and Ultrafiltration Filter.
7. When the installation has been completed, power the unit and connect it to the water source. The unit will begin to operate in about 30 minutes. Press
the cold water button to dispenser water for more than 3 minutes. Press the hot water button to dispense water for more than 3 minutes. After completing
these steps for flushing the system, the water dispenser can be used normally.
•
Turn off water supply prior to installing new filters or removing old filters.
•
Unit should be placed with a minimum of 6” (16mm) of empty space between the wall and the condenser to prevent overheating.
