Secure the faucet assembly with the
washers (1&2) and nut (3). Hand tighten
the nut (3) onto the faucet assembly. Lock
the nut (3) into position by tightening the
screws (4) with a phillips screwdriver.
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
Install the weight clip (2) at the point of the
hose marking “Weight here”.
Insert the weight (1) onto the clip (2) by
sliding it down onto the clip (2).
Make connections to water lines.
Thread the nut (1) on the supply line onto
the outlet of the water supply valve (2) and
tighten with a wrench.
Do not overtighten.
1
2
Align male fitting (1) and tabs (2) on quick
connector. Push quick connector housing
firmly upward and snap onto receiving
male fitting. Pull down moderately to
ensure connection has been made.
2
1
1
2
3
4
Optional Deck Plate Installation:
Before installation, align the hole in the
gasket (1) and deck plate (2) with the
mounting hole in the sink. Place the
faucet assembly through the deck plate
(2) and mounting hole in the sink until
the faucet assembly sets on top of deck
plate (2).
NOTE: If the sink is uneven, use silicone
under the gasket (1).
Optional Flange Installation:
Before installation, place the faucet
assembly through the mounting hole in
sink.
2
1
1
Weight
here
1
2
2
