Eliz EWH 201, Инструкция по эксплуатации

Страница: 23 / 36

23
•
To turn on this mode, press the button . Using the buttons + / - you can set the desired temperature in
the range of 18 - 45 °C, displayed on the heater by flashing numbers. Confirm the temperature setting by
pressing the OK button, or it will be confirmed automatically after 5 seconds. The default temperature is 25 °C.
•
If the set temperature is equal to or lower than the room temperature, heating does not take place.
•
If the temperature drops below the set temperature by 1 °C, the thermostat switches on the heating as follows:
•
If the set temperature is 1-2 °C higher than the room temperature, the power 1 000 W is switched on -
•
If the set temperature is higher by 3 °C or more, the full power of 2 000 W is switched on -
•
As soon as the room temperature reaches the set value, the heating is switched off, but the fan function
remains in operation.
Setting the Off timer
Working only in Temperature setting mode and fan mode. Using the button on the remote control, you can
set a timer - the remaining operating time of the heater up to a total of 8 hours in steps of 1 hour shown on the
display. The setting is automatically confirmed after 5 seconds. The heater switches off automatically when the
set time has elapsed. Turning off the device before the remaining time has elapsed clears the timer setting.
EN
TEMPERATURE SETTING MODE
WEEKLY TIMER PROGRAM
The weekly timer program can only be switched on in heating modes (LOW or HIGH), or Temperature setting
mode. Not when the heater is in a Fan mode.
The mode is switched on by pressing the button
on the remote control. When switching on this mode for the
first time (or in the event of a power supply failure), it is necessary to set the current day of the week and time!
Turning on the mode and setting the time
Press the , the display shows the day 01 (ie Monday). Use + / - buttons to set the current day from 1 to 7
(Monday - Sunday). Confirm by pressing the OK button and continue with the time setting. The display shows
time 00, ie. 0 hours. Use the + / - buttons to set the current time in hours from 1 to 23. Confirm by pressing OK
and
continue with the time setting in minutes. The display shows time 00, ie. 0 minutes. Use the + / - buttons to set the
current time in minutes from 1 to 59. Confirm by pressing OK . The display shows
P1
symbol - timer program P1
.
If you want to keep the set program
P1
, press the OK button. The weekly program indicator light is on
.
If you do not press the OK button within 10 seconds, the time setting is invalid. To reset the time, first, turn off
the heater with the power switch, then turn it on and follow the procedure above.
WARNING : We do not recommend using the LOW and HIGH heating modes separately, as the heater will heat
up to a maximum temperature of 51 °C. It is necessary to switch the heater to the Temperature setting
mode or the Weekly program mode
.
HEATING MODE SETTING
The heater can be used in 2 heating modes - Temperature setting mode
and
Weekly program mode
.
Temperature setting mode (with Off timer up to 8 hours)
- in this mode, the set temperature is automatically regulated and kept at a constant level by the thermostat
according to the set temperature (
see
Temperature setting
) until you switch off the heater. It allows you to set
the heating off timer for up to 8 hours.
Weekly program
- in this mode, the heater works and heats the air only in periods according to the selected weekly timer program.
The set temperature in the room will be automatically regulated and kept at a constant level by the thermostat
only during the time intervals of the selected timer program.