Eliz EWH 201, Инструкция по эксплуатации

Страница: 22 / 36

22
•
Place the heater on a flat wall and only in a horizontal position! It is necessary to mount the heater at least
180 cm above the floor. Keep the minimum distances among the heater, the ceiling, and the surrounding
walls - the minimum distance must be kept! - see Fig. 2.
•
Do not place the device in a vertical or leaning position. The device must not be mounted on the ceiling!
•
The minimum distance of objects from the heater should be at least 1 meter - see the Fig. 2.
Wall mounting:
•
Drill two holes in the wall at least 180 cm above floor level, 315 mm apart.
•
Make sure that the diameter of the holes is the same as dowels with a diameter
of 6 mm.
•
Insert the dowels into the holes and drive the screws into the dowels so that
the screw heads protrude approximately 10 - 15 mm from the wall. Screws and
dowels are included in the package.
•
Attach the heater with holes „A“ to the wall on the screws, move it slightly to the
right, and then down to point „B“.
•
The heater is installed, make sure that the device is stably mounted!
Power supply: ~ 220 - 240 V, 50-60 Hz ; Fuse: 10 A
The electrical installation, as well as the connection, must be carried out under the applicable regulations and
standards. The heater includes a flexible power cord with a 230 V plug. Plug the power cord into a socket with
ground contact. Do not place the heater directly below or above a power socket.
EN
ELECTRICAL CONNECTION
HEATER LOCATION
ELIZ EWH 201 is a wall-mounted electric PTC heater
designed for space heating, with electronic control,
weekly timer, and open window detection.
• 1. Cold air inlet grille, • 2. Transparent LED display,
• 3. Start / Stop button, • 4. Power switch • 5. Power
cord, • 6. Mounting / hanging holes, • 7. Hot air outlet,
• 8. Remote control, • 9. Screws and dowels
Heater description - for Fig.1
Fan indicator
1
Indicator
: - lights up when the Temperature setting
mode, - flashes when the Open window
detection
Power 1000 W - Low
Power 2000 W - High
Timer
Weekly timer mode
Temperature setting mode
DISPLAY DESCRIPTION:
1. Temperature display
•
Before connecting and switching on the heater, make sure that the socket has the protection of at least 10 A.
•
The device is controlled by the included remote control (or using the buttons on the front panel).
•
At the bottom of the remote control remove the battery foil, which protects it from discharge.
•
Plug the heater into an AC ~ 220-240 V, 50-60 Hz power socket and turn the power switch to the position I
.
•
When the power switch is turned on, the heater beeps and enters standby mode. The display shows the
current room temperature in °C.
General use:
•
The device is turned on and off by pressing on the remote control or Start/Stop on the back of the heater.
•
When the button is pressed for the first time, the heater will turn on and start operating in fan mode - only
cold air will blow. The fan indicator light is on.
•
The button is used to select the heating output level LOW / HIGH, or the fan without heating
- press the button once, the heating with a power of 1 000 W is switched on - indicator light is on -
.
- press the button twice, the heating with the full power of 2 000 W is switched on - indicator light is on -
.
- pressing the button again will turn off the heating and the heater will operate in fan mode again.
OPERATION