Parametric controller to capture plant variables in real time and signal alarm conditions when connectd to a supervisor system, both
dedicated (Televis) or standard market ones (MODBUS protocol).
USER INTERFACE
UP
1 2 3 4
5 6 7
esc
set
ESC
DOWN
SET
(ENTER)
KEYS
UP
•
Increase values
•
Go to next label
ESC
•
Exit without saving new settings
•
Go back to previous level
DOWN
•
Decrease values
•
Go to previous label
SET (ENTER)
•
Confirm value / exit and save new settings.
•
Go to next level (access to folder, sub-folder,
parameter, value)
•
Open State Menu
+
ON/OFF
Pressing and holding these keys at the same time
for 5 seconds or a remote command activates the
ON/OFF function.
In OFF mode, the screen shows the word
OFF
.
All alarms are disabled, including active and
communication ones.
Probe data capture remains active.
+
LOCK
Pressing and holding both keys together for
5 seconds or a Supervisor command locks /
unlocks the keypad.
The icon
blinks when the keypad is locked;
nothing will happen when a key is pressed, not
even the setpoint will be displayed.
LED
Icon
Description
Colour Note
Permanently on
: alarm active and output set for this alarm
Flashing
: alarm silenced and output set for this alarm
alarm active and output not set for this alarm
red
silenced from remote and/or DI
Blinks when serial communication is on
green
NOT USED
green
ON when the device is powered on but not when it is OFF
green
NOT USED
green
NOT USED
green
NOT USED
red
Temperature unit of measurement
red
Pressure unit of measurement
red
Units of measure for relative humidity
red
Permanently on
: during navigation
Flashing
: keypad locked
red
(1)
...
(7)
Manages utilities connected to the device.
Televis
In
: indicates if
D
igital
I
nputs are active (ON)
Televis
Out
: indicates if
D
igital
O
utputs are active (ON)
Amber
Televis
In
& Televis
Out
Data acquisition and alarm signalling modules.
EN
