Rev. 041217 DR
4
www.eliteproav.com
6.
Pour the mixture into a paint tray and dip the roller.
7.
Evenly apply a thin coat of adhesive to the surface with a paint roller.
8.
Wait for adhesive to dry.
9.
Sand the surface until no adhesive residue remains.
10.
Apply one coat of Professional R-35 Primer (do not allow it to dry) and immediately apply the
Insta-DE2 to the wall.
11.
Unroll the Insta-DE2 on to the wall lining it up with the drawn line from Step 3.
Note 1: Each side of the material is labeled FRONT/BACK
Note 2: Do not allow the material to wrinkle or crease to avoid permanent damage.
12.
Flatten the surface with a flexible wall smoothing tool in a 45 degree angle to avoid scratching the
surface.
13.
Lift edges and smoothen out any remaining air bubbles.
Caution:
The smoothing tool’s edge is sharp. Carefully scrape the screen when removing air bubbles to avoid scratching
the surface.
14.
Peel off the top layer of the double-sided tape and flatten the screen’s edges with the smoothing tool.
15.
Use a soft damp towel or sponge to clean entire surface.
Tip:
In rare instances, High indoor temperature will cause the surface to expand and produce bubbles.
Because the back of the Insta-DE 2 is very smooth, the glue does not easily stick to the wall by itself. For
this reason a coating of R-35 primer has to be applied to the wall.
Use a sharp utility knife to cut a small hole in the center of the bubble. Inject some Professional R-35
primer with a syringe and smooth out the Insta-DE 2 screen surface with a smoothing tool.
