GUIDE
GROOVE
Board Mounting Hole
(Mark for pre-drilling)
Position
screw in
the center
of slot
5' Porcelain Board Hanging Instructions
Note: This installation guide is used for boards of
different sizes. Due to the variances, you may receive
more hanging hardware than required for your board.
Please be sure to read all instructions before
installing your whiteboard.
STEP 1
:
Align the tray end caps with each end of the tray and firmly
push them onto the accessory tray.
See Illustration 1.
STEP 2:
Determine the desired height from the floor to the bottom of
the board. Scribe a level line on the wall at that distance. Position the
bottom edge of the accessory tray along this line. Using the groove at
the rear of the accessory tray as a guide, pre-drill 1/8" diameter holes
through the accessory tray. Fasten the accessory tray to the wall using
the appropriate hardware for the mounting surface.
See Illustration 2.
STEP 3:
Lift and center the board on the mounted accessory tray / L-
hangers. Scribe a line on the wall along the top edge of the board.
Remove the board and position the top edge of two L-hangers along this
line 6" from the edge of the board.
NOTE:
Place each screw in the
center
of each L-hanger's slot.
Fasten each L-hanger to the wall using the appropriate hardware for the
mounting surface. Be sure not to over tighten the top L-hangers, as this
may affect Step 4.
See Illustration 3.
STEP 4:
Tap the L-hangers up until the screw is resting in the lower
end of the hanger's slot. Place the board onto the accessory tray / L-
hangers and tap the top L-hangers down against the frame. Using the L-
hangers as a template, mark all the board mounting hole locations
(including lower L-hangers if used). Remove the board. Drill 1/8"
diameter holes at each of the marked locations and reattach the board
with the #8 x 1/2" screws provided.
See Illustration 4.
STEP 5 (Required for 11/16" thick boards ONLY):
Push the bottom of the board against the accessory tray/ wall. Drill 1/8"
diameter hole into the frame using the holes in the accessory tray as a
drill guide. Install #8-1" screws on each end of the tray.
WWW.GHENT.COM - LEBANON, OH - 800-543-0550
IS-M1P5-PB 05/21
1
2
3
4
5
