051215-JA
6
www.elitescreens.com
U P
St op
D own
For more information, technical support or your local Elite Screens
contact, please visit www.elitescreens.com
5. 5-12 volt trigger (Item D, Fig 4): The built-in 5-
12V trigger input allows your screen to synchronize
its drop & rise with the projector’s power cycle.
The screen deploys when the projector powers up
and will retract when the projector powers down.
The 5-12 volt RJ45 cable connects to your
projector’s trigger output via a separate cable that
may or may not be provided by the manufacturer of
the projector. The trigger feature will not work
without an output cable from the projector, but it
can be tested by connecting the Red (+) and Green
(-) cable to a 9-volt battery.
6. Wireless 5-12 volt trigger (Item F, Fig 5): The RF remote control serves as a dual purpose, independently as a
handheld remote control, or in conjunction with the Wireless 5-12 volt trigger cable. The radio frequency
technology can be programmed to send a wireless signal to synchronize its drop & rise with the projector’s power
cycle.
Here’s how to set up your Wireless 5-12 volt trigger | Synchronization Instructions
Step 1: Connect the wireless 5-12 volt trigger cable to the RF remote (3.5mm)
Step 2: Connect the 12 v adaptor end of the wireless 5-12 volt trigger cable to your projector
Step 3: Make sure to unplug your screen from the power outlet
Step 4: Hold the UP button on your RF remote
Step 5: While holding the UP button, plug the screen back to the power outlet
Step 6: Wait 5 seconds and then release the UP button
Step 7: Your 5-12V wireless trigger should now be activated with your screen and ready to be used and able to
control your screen with your projector’s power cycle
Repeat the steps again if not successful.
(Please be aware, the projector on/off cycle may take longer to fully activate. It usually takes around 20-30
seconds for full off and on cycle each time)
DC 5-12V out
Wireless 5-12V
trigger cable
The back of the
projector
Fig.4
3 prong power cord
RJ45 Input
5-12 volt trigger cable
Fig 5
