background image

02092015 EA 

 

www.elitescreens.com/kestrelhome

 

 

 
 

Controlling the Kestrel Series with 3-way wall box switch (not included): 

The following accessories are not included with  your Kestrel Hom e screen but can be 
purchases separately.  Keep this inform ation in a safe  place should  you decide to obtain 
these accessories  in the future. 
 

1.  3 - w a y   wall  s w i t c h   box: 

The 3-way wall switch box allows manual control to operate the 

screen’s 

UP/STOP/DOWN

 commands.

 

 

 

The RJ-45 input jack is located on the left side compartment which accepts the 5-12V trigger, 
extended IR “eye” receiver or the 3-way wall switch box. 
 

 
 
 

 

 

 

 

 
 

 

 

Storing the screen

:

 

Always store the screen flat horizontally. Never store the screen in 

a vertical position.

 

 

 
 
 
 
 
 
 
 
 

 
 
 
Screen Maintenance 

 

1.  Always close the screen when not in use 
2.  Do not touch the screen surface  
3.  Keep away from direct sun and high/low temperatures  
4.  For indoor use only 
5.  Clean with soft water 
6.  Do not drop/close screen consecutively for more than 3 minutes. This is to avoid 

overload protection shut-off. If automatic shut-off occurs, please wait for 20-30 minutes to 
try again. 

 
 
 
Please visit 

www.elitescreens.com

 should you need to contact us for technical support or 

service. 

Содержание Kestrel Home Series

Страница 1: ...heat protection sensor If the screen is consecutively brought up and down between 3 4 minutes the motor will automatically shut off to prevent the motor from sustaining damage through overheating If the automatic shutoff is activated please allow 30 minutes cool down before resuming operation 3 The Kestrel Home Series is equipped with a strong tension cross spring system Please do not attempt any ...

Страница 2: ...y turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures 1 The power outlet should be close to the unit and easily accessible 2 Re orient or relocate the receiving antenna 3 Increase the separation between the equipment and the receiver 4 Connect the equipment into an outlet on a circuit different from that to which the r...

Страница 3: ...n s rise and drop with the projectors power cycle The screen rises when the projector powers up and retracts when the projector powers down To enable this feature connect one end the 5 12V trigger cable to your projector s trigger output port and the other end to the RF remote control see diagram below The trigger feature will not work without if the projector does not have a 5 12V output port If ...

Страница 4: ... side compartment which accepts the 5 12V trigger extended IR eye receiver or the 3 way wall switch box Storing the screen Always store the screen flat horizontally Never store the screen in a vertical position Screen Maintenance 1 Always close the screen when not in use 2 Do not touch the screen surface 3 Keep away from direct sun and high low temperatures 4 For indoor use only 5 Clean with soft ...

Отзывы: