2
NOTE:
This equipment has been tested and found to comply with the limit s for a
Class B
digital device pursuant to Part 15 of the FCC Guidelines.
The products are designed t o provide reasonable protection against harmful
interference in a residential/commercial installation and end user application and
may radiate radio frequency energy.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. The power outlet should be close to the unit and easily accessible.
2. Re-orient or relocate the receiving antenna.
3. Increase the separation between the equipment and the receiver.
4. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
5.
Consult t he dealer or an experienced radio/TV technician f or additional help.
SCREEN OPERATION
Setup:
Remove the controls and wiring from the compartment on the left side of the
Kestrel
Floor Electric Screen as shown in the pictures below.
Connect the screen to the power supply a n d s w i t c h t h e p o w e r b u t t o n o n . N o w i t i s
r e a d y f o r u s e .
Power:
About the Control System:
1. 5-12V Trigger Input:
The built-in 5-12V trigger input for your new Elite
Kestrel
allows your
screen to synchronize its rise and drop with the projectors power cycle. The screen rises when
the projector powers up and retracts when the projector powers down.
2. IR (Infrared) and RF (Radio Frequency):
The Kestrel Series screen includes both IR and
RF receivers that enable the consumer to use either the IR remote control with direct line of
sight
through the screen’s IR receiver window. The RF remote is best used when the screen is
concealed or long distance control is required. The RF technology therefore
does not
require
line of sight directly to the screen’s IR receiver window.
ON OFF
