Rev.041717-DR
www.elitescreens.com
10
Edge trim Installation
The Aeon fixed screen is EDGE FREE®, but you may install the Edge trim to provide it with an elegant thin bezel
finish.
1.
Place the assembled frame on a flat and clean surface. The projection screen surface should be facing up.
a.
As an option, Black Tape is supplied to cover any possible gaps between the pieces of the bezel trim.
Align the tape with the edge of the screen, as shown in Figure 1. Once properly aligned, apply the black
tape to the center of the top and bottom of the screen material.
2.
Without removing the adhesive tape, place all the trim pieces along the edge of screen material. Adjust the trim
so that the top and bottom trim pieces are touching and show no gaps in the center. (Note: The Elite logo should
be positioned on the bottom right). Refer to Figure 2 below for a visual reference.
Edge trim x 6 pcs
Black tape x1bag
Front of screen
The black tape
The black tape
Next,
stretch the black backing
and affix to the hooks from the
middle
in the following sequence
a
→
b
→
c
→
d
Lastly, affix the black backing to
the remaining hooks. Add more
hooks as needed to achieve flatter
results in the areas that are not flat.
a
b
d
c
Plastic corner sleeve x4pcs
Figure 1