Elite Greenhouses WIDE MAXIM, Инструкции и иллюстрации

Страница: 12 / 28

DOOR END ASSEMBLY
From the main bag of fittings you will require the nuts and bolts, 2 eave plates and 1 ridge plate.
These are packed with the casement stay and are separate from the main bag of fittings and two
door end plates.
Components
2 Door end built in base
2 End glazing bars
2 Side corner bars (unmarked)
1 Top door track
4 Short horizontal braces (2 different lengths)
3 Diagonal bracing angles
1 Main door track support
2 Roof corner bars (marked “R”)
2 Door End Plates
INSTRUCTIONS
1. Assemble the frame in exactly the same way as the rear end, up to and including stage 3 of the
rear end. The difference with the door end is that instead of 1 long base piece, the door end
has 2 smaller pieces (1 either side of the door opening) and 1 door end cill.
2. Now engage the door end cill with the 2 built in base cills by pushing the angle of the cill
under the locator as shown in the diagram. At this stage the cill will move freely left and right
but will remain located to the built in base cill.
3. Slide 2 bolts into the bottom of each glazing bar and 3 bolts
(only 1 if greenhouse to be sited on soft ground) into the
free end of each built in base section. Attach the 2
nd
bolt in
the glazing bar to the hole in the door end cill, but do not
put a nut on yet.
4.
Attach the door end plate (with 3 holes) to the 2 bolts
inserted in the glazing bars and the last bolt inserted into
the base ensuring that the glazing bar is tight down into the
angle of the door end cill. Attach the diagonal angle to the
top bolt of the door end plate. The 2 unoccupied bolts in the
base sections will be used to anchor the greenhouse to the
floor.