ELIS PLZEŇ a. s.
Project design, installation and service manual
Page 23 o
f
33
Electromagnetic flowmeters of the type series
FLONEX FXx11x and FLONET FH30xx
Meter control instructions
ELIS PLZE
Ň a. s., Lucni 425/15, 301 00 Plzeň, Czech Republic tel.:+420 377 517 711, fax:+420 377 517 722
Es 90 686 K
Confirm the setting by
ENTER
whereby the display will return to the previous menu item (
Flow rate limit
[1] / Hysteresis [1].
Return to Main menu:
3 x ESC
Return to Basic screen:
ESC 2 s
The flow rate limit value shall always be set in litres per second. Conversion of volume flow rates in
various units to flow rate in litres per second is described above in the procedure for setting the
100%
value.
5.1.4.4.9. IQI > Qlim
The parameter setting procedure is essentially the same as that for Q > Qlim.
5.1.4.4.10. No error
Upon confirming by
ENTER
the selection of the menu item
No error
,
Output 1
will be ready for reporting a
flowmeter error.
In the error-free condition Output 1 will be open (disconnected).
A correct function selection will be confirmed by return of the display to the previous menu item.
Upon selecting the
Function negation
mode, the output signal will be negated (in the error-free
condition
Output 1
will be constantly closed).
Return to Main menu:
2 x ESC
Return to Basic screen:
ESC 2 s
5.1.4.5.
Serial line
Selection using
buttons
► and ▲
Using buttons
▲ and ►, select in the yellow highlighted field the flowmeter address for interconnection to
the communication network.
Confirm the selection by
ENTER
whereby the display will return to the previous menu item.
Return to Main menu:
1 x ESC
.
The meter address can only be selected from the range of 1 to 247. Other address values will be
rejected.
The initial flowmeter address is 4.
Address
Baud rate
Address
004
ENTER
Output [1] function
No error
ENTER
