Elipson INFINITE INF6, Руководство пользователя

Страница: 7 / 11

EN
12 13 13
Preparation of mounting surfaces / Finishing of ceilings
Prior to start the installation of the speakers, it will be necessary to run cables to the speaker
locations. See your dealer for more information on cable installation. After the cable has
been properly installed, you are ready to mount the speakers.
IV. INSTALLATION
1. Determine the best area to mount your speakers
This area of the ceiling or wall should be free of obstructions such as electrical conduit,
HVAC ducts, or water lines. If possible, you should access to an attic or crawl space in order
to best noting the location of such obstacles.
2. Find the eventual beams / joists near the desired speaker mounting location
We highly recommend you to use a good stud-finder tool for this procedure. If you are
placing the speakers really close to some studs or other object, make sure you consider the
size of the baffles flange, which extends beyond the mounting hole.
3. Make the hole
A punch out template for setting the hole is provided in the box. Position the template in
the desired position and pencil an outline on the wall or ceiling.
4. Cutting the hole
Caution : this is the most important part of the entire installation. If you are uncertain about
obstructions in the mounting area, you should start by cutting a small hole within the
penciled area with a drywall saw. Cutting at a 45 degree angle will make drywall repair
much easier if you need to repair the hole because of unexpected obstructions. Once you
have determined there are no obstructions in your desired mounting location, start cutting
the finished hole at a 90 degree angle to the wall surface.
5. Add insulation
If the area in the ceiling or wall is not already insulated, add an adequate amount of
insulation material to fill the cavity. If the insulation material used is cover with foil or paper,
position the foil or paper away from the speaker.
The mounting-feet sytem integrated into your speaker makes its installation very quick and
easy to do, following only few steps.
1. Remove the grill and set aside in a clean dust-free environment.
2. Binding post terminals provide reliable contact for bare wire. Fix the cable of the speaker
respecting the polarity of your amplifier (+ with + and - with -). Make sure the left channel of
the amplifier is connected to the left channel of the speaker, and that the right channel of
the amplifier is connected to the right channel of the speaker. A polarity inversion will result
in a fuzzy stereo image and a low level of bass.