www.elinz.com.au / [email protected] / 1300 881 773
Camera Positioning
Camera location
Wiring Installation
The system can be used as a rear observation system or as a backup camera system
.
·
To use as a rear observation system
,
the camera needs to be wired to a constant
12V
/
24V power source
.
Ex
:
If connected to running lights or marker lights
,
the
lights must be ON for the system to operate
.
·
To use system as a backup camera system
,
the camera needs to be wired to a circuit
that turns on when the reverse gear in engaged
.
Ex
:
Backup lights
.
1.
Chose routing path for the camera
'
s power cable to the power source
depending on the desired function
.
2.
Before drilling the hole
,
make sure there are no components behind the surface you
are drilling such as electrical cables
,
gas lines
,
or other important components that can
be damaged.
3.
After drilling the hole
,
insert the supplied grommet then route the camera cable into
the opening.
The grommet must be used to prevent the metal edge from cutting the cable
.
4.
Locate the power source required
:
Backup lights if used as a backup camera or
running
/
marker lights is used as a rear observation system.
5.
Once you have located the power source
,
route the camera cable to that location
.
Never route the cable on the outside of the vehicle.
