Fig. 1
3.5mm SYNC
socket
Operating Instructions
1. Connect the SYNC cable to the EL-Skyport SYNC socket and the flash unit SYNC socket.
Use included SYNC cable.
2. Check the correct Group and Channel setting for the
Transmitter
and
Universal Receiver
.
3. Switch ON the EL-Skyport
Universal Receiver
and
Transmitter
4. Switch flash unit ON and press “TEST” push button on EL-Skyport Transmitter for a Test
flash.
Operating Modes
1.
Battery mode:
Charge LED flashes when switched
ON
. If not used for
4 hours
, the unit
will switch to
Stand-By Mode
(switch Receiver
OFF and ON
to return to normal mode)
2.
Supply mode:
With Wall-Adapter Charger plugged in for long term fixed operation
Note:
If the EL-Skyport Receiver is used whilst charging (in Supply Mode), the Universal Receiver
will not change to Stand-By mode.
Frequency
channel selector
Flexible swivel
Antenna 360 ̊
Charge socket for
EL-Skyport Wall Charger only
GROUP switch
ON/OFF switch
Status LED (green)
Frequency Channel
Note:
Transmitter and the corresponding
RX
Transceivers
or
Universal Receivers
must have
the same frequency channel setting !
Frequency
Channel
Slide Button configuration
Trigger
Frequency
/ Mhz
Remote
Frequency
/ Mhz
1
2
3
1 (default)
Off
Off
Off
2456
2448
2
On
Off
Off
2458
2450
3
Off
On
Off
2460
2452
4
On
On
Off
2462
2454
5
Off
Off
On
2469
2461
6
On
Off
On
2471
2463
7
Off
On
On
2473
2465
8
On
On
On
2475
2467
Note:
After changing the frequency, switch Receiver
OFF and ON
again to activate the new settings.
Trigger Group Settings
The
EL-Skyport Transmitter
triggers the
Universal Receiver
in following modes:
1.
Groups(1 to 4)
sets and triggers flash units in different “
Groups
”
è
only Flash Units with the selected
Group
are triggerd by the Transmitter
(
Group
setting must correspond between
Transmitter
and
Receiver
)
2.
ALL
Transmitter
is set to
ALL
è
The
Transmitter
triggers all
EL-Skyport Receivers
4
5
