18
Control panel with 6 buttons
To select the functions of the hood just touch the commands.
Light key ON/OFF
Intensive speed selection key
(suction
power) - duration 5 minutes
:
the hood sets this
power and at the end of the 5 minutes returns
to the previous setting.
High-speed selection key
(suction power).
Medium-speed selection key
(suction power)
- when flashing it indicates the need to wash or
replace the carbon filter. This signal is normally
deactivated. To activate the alarm, disable the
electronic by pressing the
0
button for 3
seconds.
Next, simultaneously press buttons
1
and
2
for
3 seconds; at first, only button
1
will flash, then
both buttons
1
and
2
will flash to indicate
activation. Repeat the procedure to deactivate
the alarm; at first buttons
1
and
2
will flash and
subsequently only button
1
to indicate
deactivation.
Low-speed selection key
(suction power) –
when flashing it indicates the need to wash the
fats filter.
Motor key OFF
(stand by) – excludes the
electronics – reset wash/replace filters signals.
MOTOR OFF
Press briefly to switch the motor off.
RESET FILTERS SIGNALS
In functioning mode, after carrying out filter
maintenance, press the key until hearing the
sound signal. The flashing LED
1
(grease filter)
or
2
(carbon filter) stops flashing.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood
command electronics will be excluded.
This function can be useful during the product
cleaning operations.
Just repeat the operation to reinsert the
electronics.
If the hood fails to operate correctly, briefly disconnect it from
the mains power supply for almost 5 sec. by pulling out the
plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.
Maintenance
Cleaning
Clean using
ONLY
a cloth dampened with neutral liquid
detergent.
DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS
. Do not use abrasive products.
DO NOT USE
ALCOHOL!
Grease filter
Fig. 11
Traps cooking grease particles.
The grease filter
must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
Fig. 12
It absorbs unpleasant odors caused by cooking.
The saturation of the
charcoal filter
occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four months.
The charcoal filter may NOT be washed or regenerated.
Circular charcoal filter
Apply one on each side as cover to both the shield grids of the
motor impeller, then turn clockwise.
For the disassembly, turn counter-clockwise.
Replacing lamps
Fig. 10
Disconnect the appliance from the electricity.
Warning!
Prior to touching the light bulbs ensure they are
cooled down.
Replace the old light bulb with the one of the same type as
specified in the feature label or near the light lamp on the
hood.
1.
Using a flat head screwdriver or equivalent tool, carefully
pry loose the light cover.
2.
Replace the damaged LED or halogen lamp, with one
having the same characteristics, as specified in the label
features or near the lamp:
LED lamp:
For replacement, contact the technical
service
.
Halogen lamp: 12V - 20W max - G4 (take care not to
touch them with your hands)
3.
Reinstall the light cover. (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
