8
6 Slide out mounting plate to the left from under the motor
mounting bracket.
A
B
A. Motor mounting plate
B. Motor mounting bracket
A
B
A. Motor mounting plate
B. Motor mounting bracket
7 Remove the range hood internal blower motor.
8 Replace the grease filters on the hood.
Prepare for Mounting the In-Line Blower System
The In-Line Blower System must be fastened to a secure
structure of the roof, ceiling, wall, floor, or new or existing
frame construction. The 4 holes on either the inlet (bottom)
side or the outlet (top) side of the blower must be used to
mount the in-line blower system to the structure.
NOTE:
The mounting hole locations must span the studs.
Additional stud framing may be required. Plywood may be
used to span open areas between ceiling joists or roof rafters
to aid installation. This structure must be strong enough to
support the weight of the in-line blower system (50 lb [22.6
kg] min).
Prepare the In-line Blower System
I
WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
1 Disconnect power.
2 Determine which venting method to use: roof or wall
exhaust.
3 Remove the 6 - 6.5 x 3.5 mm screws from the front cover
of the shell and save them for later. Remove the front cover
of the shell and set it aside.
4 Remove the 6 - 4.2 x 8 mm screws from the back of the
shell.
A
B
A. Front cover
B. Back of the shell
5 Rotate the shell and place it with the back over a covered
surface.
6 Remove 4 - 4.2 x 8 mm screws from each side cover and
remove the covers.
A
B
B
B
B
A. Side covers
B. 4.2 x 8 mm screws
For models EAR134S4, EAR140S4, EAR146S4, ECL136S4,
ECL142S4, ECL148S4, ETR134S1 and ETR146SS
Fix support bracket and spring tab, support brackets to the
appropriate screw slots following the next image.
B
A
C
D
A. Support bracket
B. Spring tab
C. 3 - 4.2 x 8 mm screws
D. 2 - 4.2 x 8 mm screws
Содержание KIT0179549
Страница 44: ......
