36
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
M
M
a
a
n
n
u
u
a
a
l
l
9.2 Replacement of paper
9.2.1 Replacement of printer paper
If a red line appears on the
paper, or if ‘NO PAPER’ message is displayed on the screen bottom,
please replace printer paper with new one.
[ Drawing 29 ] Replacment of printer paper
[ Drawing 30 ] Insert location of printer paper
a. Rotate the joystick clockwise to lift up the body, and then open printer cover.
b. Insert the printer paper from below to the insert slit or the black printer unit, and then
push it up softly. Keep the lid of the printer unit closed while inserting. The paper will be
drawn in automatically. Make sure the printable side (smoother side) faces downwards
at the insert.
c. Insert the end of paper (which comes out from the printer) into he slit of the printer cover,
then close the cover.
** If paper was not inserted enough, pull it carefully by hand.
** Please check paper type and size.
(Paper type: Thermal paper, width 57mm, external diameter 50mm)
9.2.2 Replacement of chinrest paper (if used)
a. a. Pull out the 2 holding pins on the chinrest.
b. b. Insert holding pins into the hole of chinrest paper (more than 50 pcs available).
c. c. Insert the 2 holding pins with the paper into the hole on the chinrest.
9.2.3 Replacement of headrest paper (if used)
a. Headrest paper is attached to the forehead.
b. After the measurement the paper is removed.
c. After removing the headrest paper, clean 1~2 times with a soft cloth.
9.3 When Moving the Instrument
a. Turn OFF the power switch.
b. Disconnect the power cable
c. Close the stage holding dial in the Colckwise direction
d. Move this machine holding the lower part of the mains to keep horizontally.
Insert location
