17
R
R
e
e
f
f
r
r
a
a
c
c
t
t
o
o
m
m
e
e
t
t
e
e
r
r
/
/
K
K
e
e
r
r
a
a
t
t
o
o
m
m
e
e
t
t
e
e
r
r
E
E
R
R
K
K
7
7
8
8
0
0
0
0
5. Equipment Installation and Measurement Preparation
5.1 Connect power cord
- Put ERK 7800 on the table
- Plug power cord into power connector
- Ensure the power switch is turned OFF, plug power cord into electrical outlet
5.2 Release stage fixing
- Rotate stage clamping bolt located in the buttom of body unclockwise and release
- Lift stage holding knob staright up forward to
‘
UNFIXING
’
- Push stage to left and right and then loosen uder stage fixing bolt.
- Check whether stage is moving freely.
5.3 Screw in the 2 rubber bolts
- They are located between the moving stage and the base of the body (not shown in the picture).
Move the stage to the side as much as possible (left and right) for easier access. Turn the two
black rubber bolts clockwise until they are completely turned in.
- Check whether stage is moving freely.
5.4 Chin rest paper (if used)
- Remove both pins from the chin rest.
- Slit both pins into the holes of the chin rest paper and attach them again on the chin rest.
5.5 Printing paper
- Check if printing paper is properly installed.
- Install new paper if needed (refer to section 9.2.1 Replacement of printer paper).
Turn off the power after connecting or disconnecting the power cable.
Do not operate the unit with wet hands to prevent death or serious injury
from electric shock.
[ Drawing 5 ] Stage Clamping
[ Drawing 6 ] Stage Clamping
Bolt
