Elgento E19019N, Инструкция по эксплуатации

Страница: 7 / 12

7 www.elgento.co
USING YOUR APPLIANCE:
1. Plug the Can Opener in.
2. Raise the lever into the upright position.
3. Insert the can so that the lower edge of
the can lip rests on top of the drive wheel.
Ensure that the cutting edge is on the
inside of the can lip.
4. Push the can opener lever down firmly
until the can is fully open. When the
can is fully open, the cutting action will
automatically stop. The can will remain in
position until the lever is raised.
5. To release the can, grasp the can firmly
in one hand and raise the lever with the
other hand. The magnetic lid holder will
retain the lid.
CAUTION! When removing the lid there
may be some sharp edges. Do not touch
them to avoid injury.
Dented Cans:
Dented cans may cause the can opener to
stall. If this happens, grasp the dented can and
guide it through the cutting action manually until
the damaged areas are passed.
Jammed Cans:
To open a can that has become jammed, raise
the can opener lever and release the can. Begin
the cutting action again in a new place on the
can lip.
USING AS A KNIFE SHARPENER:
1. Ensure the knife is clean and free of
grease.
2. Place heel of knife into the guide slot
located on the back of can opener.
Note: It may help for the can opener to placed
sideways while using the knife sharpener.
3. Press the lever down and lightly draw
the blade towards you, applying slight
downward pressure.
Note: Do not let the knife cut into the body of
the can opener.
4. Repeat this procedure six to seven times
to sharpen the knife.
Do not attempt to sharpen hollow ground
blades or those with serrated edges.
The grinding wheel may jam if too much
pressure is applied on the knife. Lift the knife
slightly to release the wheel.
USING AS A BOTTLE OPENER:
1. Ensure the bottle cap is clean.
2. Hold the bottle and put the cap in to the
metal hooks.
3. Pull bottle down to remove the cap.
Note: The bottle opener will only remove metal
bottle caps.
When opening tall bottles, the unit should
be used towards the edge of a work top.