Page 13
On/Off Plug-In Switch Advanced User Manual
Compatible Command Classes
Command Class
Notes
Association V2 (85)
Group 1
Group 1 is the “Lifeline” group, which can hold five devices. The
On/Off Plug-In Switch sends this group a Notification Report and Bi
-
nary Switch Report whenever it is turned on or off. It also sends a
Meter Report incrementally based on time (see Param 2,) or when a
relative change in power usage is detected (see Param 6.) Finally, the
On/Off Plug-In Switch sends this group a Device Reset Locally notifica
-
tion to remove itself from the Z-Wave network.
Group 2
The On/Off Plug-In Switch sends a BASIC_SET(FF) command to Associ-
ation Group 2 to directly trigger devices (like a siren, chime, etc.) when
the current passes above the level set in Parameter 3. When the current
drops below the level again, a BASIC_SET(00) command is sent to reset
the device (e.g. turn off the siren.) This Group can hold five devices.
Group 3
The On/Off Plug-In Switch sends Notification Reports to Group 3, and it
can hold five devices.
Notification V4 (71)
The On/Off Plug-In Switch sends a NOTIFICATION_REPORT to Group
1 when the current load passes the level set in Param 3, and
another report when it drops back below this level. See below for the
NOTIFICATION_REPORT parameters sent:
Returned Value:
00 00 00 FF 08 XX 00 00
V1 Alarm Type
: 00
(Unsupported)
V1 Alarm Level
: 00
(Unsupported)
Reserved
: 00
(Reserved)
Notification Status:
FF
(Unsolicited Reporting is Enabled)
Notification Type
: 08
(Power Management)
Event
:
Overload Detected
—08
(Overload Detected)
No More Overload
—00
(Event Inactive)
Sequence/Reserved/Event Parameters Length:
00
Notification Event Parameters
: 00
(No Event Parameters)
Table 5 - Command Classes Continued
