18 | EN
Ⓒ
elero GmbH
Ⓒ
elero GmbH
EN | 19
4.6 Programming the radio/transmitter/channel
Requirement:
The Invio-868/Invio-915 must be installed. In addition to this,
a Venetian blind switch or an another
elero
ProLine control
device must be connected.
1. For previously installed electric receivers, turn the safety fuse
off and then back on again after a few seconds. The receiver
will now be in programming mode for 5 minutes.
2. Press the Invio-868/Invio-915 programming button
P
for at least
1 second. To assign movements to the travel keys (
UP
and
DOWN
), press the
DOWN
key on the keyboard or the control
device immediately after beginning a descent (within 1 second).
3. Immediately after beginning an ascent (within 1 second), press the
UP
key on the keyboard or on the control device. Result: The shut-
ter/blind/awning will stop. The Invio-868/Invio-915 is programmed.
Important note for programming the radio:
The Invio-868/Invio-915 does not have a separate
STOP
button
(unlike the other
elero
transmitters).
In order to stop a programming procedure, the programming
button
P
must be released at least once. After this, the pro-
gramming button
P
will work like a
STOP
button.
Outside of the programming procedure, the programming but-
ton
P
will not act as a
STOP
button (any longer). Instead, it will
work just like a conventional programming button
P
.
4.6.1 Intermediate position/ventilation position
Intermediate position for
Roller shutters
Awnings
Venetian blinds
Pos
Intermediate
position
Intermediate
position
Intermediate
position
Pos
Ventilation
position
Fabric tautening Turning position
Fig. 4 Intermediate positions for roller shutters/awnings/Venetian
blinds
Important:
The intermediate position or ventilation/tilting position
Can only be programmed and deleted using an
elero
ProLine
control device or a (programmed) handheld transmitter
Cannot be programmed or deleted using the Invio-868/Invio-915
Cannot be programmed or deleted using a Venetian blind
switch.
4.6.2 Moving to the intermediate position
Requirement:
The Invio-868/Invio-915 must be programmed.
1. On the Venetian blind switch
▼ ▲
, press the
DOWN/CLOSE
button twice in quick succession.
2. The drive travels to the saved intermediate position.
If there is no programmed intermediate position, the blind travels
to the lower end position.
Содержание Invio-868
Страница 13: ...Ⓒ elero GmbH ...
