elero AstroTec, Руководство по эксплуатации

Страница: 15 / 20

Programming
GB-28
Programming
GB-27
SETTING
HOLIDAY, LIGHT SENSOR (Holiday OFF/ON, sun/twilight setting)
SETTING HOLIDAY OFF
HOLIDAY ON
LIGHT
SENSOR
CONNECTED ?
SUN
TWILIGHT
OK
OK
OK
+/–
+/–
+/–
OK
see
next page
1. Press the MENU button.
2. To select the SETTING menu, press the + button until SETTING
appears.
3. Confirm by pressing OK . HOLIDAY ON/OFF will appear.
4. You can set the holiday function to ON or OFF by pressing
the +/- button.
5. Confirm your selection by pressing OK .
Note: This dialog window will only be displayed if a light sensor is
connected to the device.
You have confirmed the holiday function. SUN will appear.
The value set is displayed.
6. You can reset the sunlight setting by pressing the +/- button.
(The two digits at the left of the display show the current light
value)
7. Confirm your entry by pressing OK .
To set the TWILIGHT SETTING, follow the same procedure as for
SUN.
The function SUN/TWILIGHT SETTING has now been set.
Please read on for further programming options using the
SETTING menu.
SETTING
INTERMEDIATE POSITION, VENTILATION/REVERSE, PROG 1 END LIMIT
(Time/ position programming)
See
previous page
INTERMEDIATE
POSITITION VENTILATION
(REVERSE) PROG1
END LIMIT
OK
PROG1
INTERMEDIATE
POSITION
PROG1
VENTILATION
See
next page
OK
OK
+/–
+/–
+/–
+/–
OK
OK
You have confirmed the HOLIDAY/
LIGHT SENSOR menu levels.
INTERMEDIATE POSITION will appear.
1. You can set the switching time to move to the INTERMEDIATE
POSITION using the +/- button. The switching time is indicated in
a few seconds or you can move to the INTERMEDIATE POSITION
from the upper end limit using the
UP/DOWN button.
2. Confirm by pressing OK .
3. You can set the switching time to move to VENTILATION/REVERSE
using the +/- button. The switching time is indicated in a few
seconds or you can move to the VENTILATION/REVERSE from the
lower end limit using the
UP/DOWN button.
4. Confirm by pressing OK . PROG1 END LIMIT appears.
5. You can select PROG 1 END LIMIT, PROG 1 INTERMEDIATE POSITION
and PROG 1 VENTILATION/REVERSE using the +/- button.
6. Confirm your selection by pressing OK .
The function PROG1 END LIMIT has now been set.
Please read on for further programming options using the
SETTING menu.
GB