Pre-Installation Continued
This RO system uses quick connection push-in fittings. These fittings only require a firm push to connect the tube.
Connecting Standard Quick Connection Push-in Fittings
Step 1:
Remove locking clip from the fitting as shown in Fig. 1
Step 2:
Push tube into the fitting (Fig. 2). The collet (gripper) has stainless steel teeth which hold the tube firmly in
position while the O-ring provides a permanent leak-proof seal. Pull on the tube to verify it has been
secured. It is a good practice to test the system prior to leaving the site and/or before use.
Step 3:
Place the locking clip back (Fig. 3) to lock the tube and prevent it from accidental slip-out.
Figure 1
Figure 2
Figure 3
Disconnecting Standard Quick Connection Push-in Fittings
Caution! Make sure that the system is depressurized before removing fittings.
Step 1:
If present, remove locking clip from the fitting as shown in Fig. 4.
Step 2:
Push in the collet against the face of the fitting (Fig 5). With the collet held in this position the tube can
be removed (Fig. 6). The fitting can then be re-used.
Figure 4
Figure 5
Figure 6
6
