background image

Troubleshooting

Symptom

Probable Causes 

Corrective action

Floor does not heat

No power at controller

Check Power supply

MCB Tripped

Check the circuit is not overloaded or short circuited

Thermostat not set correctly

Refer to thermostat Instructions

eRibbon not correctly connected with thermostat

Refer to thermostat Instructions

Floor temperature sensor not connected

Refer to thermostat Instructions

Faulty sensor/thermostat

Contact the eLine Helpdesk 08714 74 08 18

Heating element cut or damaged

Contact the eLine Helpdesk 08714 74 08 18

Floor warming all the time

Thermostat not set correctly

Refer to thermostat Instructions

Floor temperature sensor not connected

Refer to thermostat Instructions

Floor not getting warm enough 

Thermostat not set correctly

Refer to thermostat Instructions

Floor sensor to close to heating element

Contact the eLine Helpdesk 08714 74 08 18

Contact the eLine Helpdesk with any questions on 08714 74 08 18

e

Ribbon

Edison House, Unit 7,
Edison Close, Ransomes Europark,
Ipswich, Suffolk, IP3 9GU
United Kingdom 

Copyright Elements, a trading division CJ Electrical (Ipswich) Limited. Registered in England no. 2895711

Troubleshooting

Tel:  01473 27 66 80
Fax: 01473 27 66 78
Email: [email protected]
Web: www.electricunderfloorheating.co.uk

8

devilink™

`

The   

  

asy

 

choice for underfloor heating

eCentral

An easy to use touch screen panel which 
offers complete control over your entire 
heating system wirelessly from one 
central control – devilink™.

eStat

Provides total control and flexibility 
when using your underfloor heating 
system. With the options of both manual 
and fully programmable controls.

eDemist

An ultra thin self-adhesive heating 
pad that fits inconspicuously behind 
virtually any mirror keeping the mirror 
completely mist free.

Call 01473 27 66 80 to receive the latest
underfloor heating catalogue  

eGuard Monitor

Monitors mats and cables for faults 
during installation.

Содержание eRibbon









Отзывы: