43
Element4 Gas Fireplaces Rev #01272020
www.European
Home
.com
OPERATING the FIREPLACE
BEFORE THE FIRST FIRE
1. Make certain that all construction materials have been removed from inside and around the fireplace and the fireplace has
been cleaned of any construction dust. Clean the glass BEFORE and AFTER the first fire.
2. Confirm that the gas valve is properly connected and bled by a certified gas technician or plumber.
3. Check the gas supply for leaks and proper pressure. Refer to the table in “Appliance Ratings” section.
4. Check that the venting is unobstructed and in proper working condition.
5.
5. PROPERLY PLACE, CLAMP, AND SEAL THE GLASS PANELS.
PROPERLY PLACE, CLAMP, AND SEAL THE GLASS PANELS.
6. Ensure the receiver is powered with an AC Adapter
OR
Batteries,
NOT BOTH
.
7. Place the two (2) AAA batteries into the remote control and confirm that it will communicate with the receiver by pressing
the
ON
/
OFF
button. If necessary pair the remote and receiver (see below).
8. Follow
USING THE REMOTE CONTROL ELECTRONIC IGNITION SEQUENCE
to setup and use remote.
Note!
For normal operation the
MANUAL
knob on the gas valve cannot be in the
MAN
position; it must be fully in the
ON
position.
This knob is AUTOMATIC and will turn
to OFF when the fireplace is turned
off and to ON when the fireplace is
turned on.
MANUAL
KNOB IN
ON
POSITION
MAIN VALVE
KNOB
IN
ON
POSITION
After removing the black plastic plug, turn the screw
counterclockwise to lower the pressure and clockwise
to raise the pressure. This adjustment is required for fuel
conversions.
PRESSURE REGULATOR
SCREW
GAS VALVE KNOBS
PAIRING THE REMOTE AND RECEIVER
(System Reset)
1. Press and hold the receiver reset button using a small, long tool until you
hear the second of two beeps. After the second beep release the reset
button.
2. Press and hold the button on the remote until you hear the second of two
beeps. Release the button.
If you hear one long beep, this indicates the pairing sequence has failed or the wiring
is incorrect. Re-synch the remote.
RESET
BUTTON
OVERVIEW
The Club 140 Series fireplaces may be controlled with one of two devices; the included remote control or the Element4 ProContol
app on your iOS/Android mobile device.
The ProControl app is required for control of both the fireplace flames and the LED lights and is available at either the Apple App
Store or Google Play.
The remote control allows control of the fireplace flames only.
Figure 76
Figure 77
Содержание Club 240H C
